NEC NEC-80570 User Guide - Page 48
Maintenance Options and SMDR, Source System
UPC - 714627059029
View all NEC NEC-80570 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Database Transfer Utility If the destination system does not recover from the reset, the transfer was incomplete and the database has become corrupted. You'll need to shut the system down, pull the battery from the CPU (for about 5 minutes) and then restart the system. The default database will automatically be reinstalled. 9. When the Database Transfer completes, set the MODE switch on the source system back to RUN and press the red reset button. 10. To repeat the Database Transfer procedure, you must start over again from step 1. Table below explains the Power LED flash rates that occur during Database Transfer. Power LED Flash Rates During Database Transfer Source System Destination System While Database Transfer is in progress: When Database Transfer completes: Flashes briefly red, then flashes green. Flashes red/green. Flashes briefly green, the alternately flashes red and green. Flashes slowly green. 5-8 x Section 5: Maintenance Options and SMDR DS1000 Hardware Manual