Netgear FS728TP-100NAS FS728TP User Manual - Page 18
Network without a DHCP Server, Manually Assigning Network Parameters
View all Netgear FS728TP-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
FS728TP Smart Switch FS728TP Smart Switch Software Administration Manual 8. Use your web browser to manage your switch. The default password is password. Then use this screen to proceed to management of the switch covered in Chapter 2, "Introduction to the Web Browser Interface". Network without a DHCP Server This section describes how to set up your switch in a network without a DHCP server, and is divided into the following tasks: • Manually assign network parameters for your switch • Configure the NIC settings on the host PC • Log in to the web-based switch management utility Manually Assigning Network Parameters If your network has no DHCP service, you must assign a static IP address to your switch. You can also assign the switch a static IP address even if your network has DHCP service. Proceed as follows: 1. Connect the FS728TP 10/100 PoE Smart Switch with Gigabit Ports to your existing network. 2. Power on the switch by plugging in the AC-DC power adapter. The default IP is 192.168.0.239. 3. Install the SmartWizard Discovery utility on your computer. The SmartWizard Discovery utility is located on the switch installation CD. 4. Start the SmartWizard Discovery utility. 5. Click Discover for the SmartWizard Discovery utility to find your FS728TP 10/100 PoE Smart Switch with Gigabit Ports. You should see a screen similar to that shown in Figure 1-1. 6. Click Configuration Setting. A screen similar to that shown below appears. Getting Started with Switch Management 1-5 v1.0, December 2007