Netgear GSM7252PS 7200 Series Managed Switch CLI Refernce Manual for Software - Page 180

ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3 set igmp maxresponse This command sets the IGMP Maximum Response time for the system, or on a particular interface or VLAN. The Maximum Response time is the amount of time in seconds that a switch will wait after sending a query on an interface because it did not receive a report for a particular group in that interface. This value must be less than the IGMP Query Interval time value. The range is 1 to 25 seconds. Default Format Mode 10 seconds set igmp maxresponse • Global Config • Interface Config Format Mode set igmp maxresponse VLAN Config no set igmp maxresponse This command sets the max response time (on the interface or VLAN) to the default value. Format Mode no set igmp maxresponse • Global Config • Interface Config Format Mode no set igmp maxresponse VLAN Config set igmp mcrtrexpiretime This command sets the Multicast Router Present Expiration time. The time is set for the system, on a particular interface or VLAN. This is the amount of time in seconds that a switch waits for a query to be received on an interface before the interface is removed from the list of interfaces with multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite timeout, i.e. no expiration. Default 0 Switching Commands v1.0, May 2010 3-142