Netgear GSM7252PS 7200 Series Managed Switch CLI Refernce Manual for Software - Page 25

ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3 Table 8. CLI Editing Conventions (continued) Key Sequence Exit ? Description Go to next lower command prompt List available commands, keywords, or parameters Using CLI Help Enter a question mark (?) at the command prompt to display the commands available in the current mode. (switch) >? enable help logout ping quit show telnet Enter into user privilege mode. Display help for various special keys. Exit this session. Any unsaved changes are lost. Send ICMP echo packets to a specified IP address. Exit this session. Any unsaved changes are lost. Display Switch Options and Settings. Telnet to a remote host. Enter a question mark (?) after each word you enter to display available command keywords or parameters. (switch) #network ? javamode mgmt_vlan parms protocol Enable/Disable. Configure the Management VLAN ID of the switch. Configure Network Parameters of the router. Select DHCP, BootP, or None as the network config protocol. If the help output shows a parameter in angle brackets, you must replace the parameter with a value. (switch) #network parms ? Enter the IP address. If there are no additional command keywords or parameters, or if additional parameters are optional, the following message appears in the output: Press Enter to execute the command You can also enter a question mark (?) after typing one or more characters of a word to list the available command or parameters that begin with the letters, as shown in the following example: Using the Command-Line Interface v1.0, May 2010 1-11