Netgear GSM7252PS 7200 Series Managed Switch CLI Refernce Manual for Software - Page 270

ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3 poe power limit This command configures the type of power limit for a port. If the power limit type is "userdefined", the command will also allow you to configure a maximum power limit. The possible options are: • dot3af - Allows the port to draw upto the max class power based on the class of the device connected. • none - Allows the port to draw upto Class 0 max power if in low-power mode and upto class 4 max power if in high-power mode. • User defined - Allows the user to define a max power to the port. This can be a value between 3000 and 32000 mW. Format Mode Default poe power limit {dot3af | none | user-defined []} Global Config Interface Config None. The default user defined max power limit is 15.4 Watts. no poe power limit This command will set the power limit type to default. It will also set the maximum power limit to default if the power limit type is "user-defined". The default power limit type will be "none". The default user defined max power limit will be 15.4 Watts. Format Mode no poe power limit [user-defined] Global Config Interface Config poe power management This command configures the power management mode on the PoE switch. Both Static and Dynamic Power management modes will not power up a port if the available power is less than the power limit defined for a port. The difference is in how the available power is calculated for these modes. • Static Power Management Available Power = Power limit of the Source - Total allocated power Power Over Ethernet Commands 5-5 v1.0, May 2010