Netgear WG302 WG302v1 Reference Manual - Page 74
Using the Reset Button to Restore Factory Default Settings, Reboot., Reset to Factory Defaults. - reset factory default
UPC - 606449030365
View all Netgear WG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302 • Check whether other PCs work. If they do, ensure that your PCs TCP/IP settings are correct. If using a Fixed (Static) IP Address, check the Subnet Mask, Default Gateway, DNS, and IP Addresses. • If the PCs are configured correctly, but still not working, ensure that the WG302 is connected and turned on. Connect to it and check its settings. If you cannot connect to it, check the LAN and power connections. • If the WG302 is configured correctly, check your Internet connection (DSL/Cable modem etc.) to make sure that it is working correctly. • Try again. Using the Reset Button to Restore Factory Default Settings The Reset button (see "WG302 rear panel" on page 2-7) has two functions: • Reboot. When pressed and released quickly, the WG302 will reboot (restart). • Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL settings to the factory default values. To clear all data and restore the factory default values: 1. Power off the WG302 and power it back on. 2. Use something with a small point, such as a pen, to press the Reset button in and hold it in for at least 5 seconds. 3. Release the Reset button. The factory default configuration has now been restored, and the WG302 is ready for use. 6-4 Troubleshooting September 2004