Netgear WMS5316-Wireless Reference Manual - Page 54
SNMP for Access Point Groups, Read-Only Community Name, Trap Community Name
View all Netgear WMS5316-Wireless manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
ProSafe 16 AP Wireless Management System WMS5316 SNMP for Access Point Groups Enable SNMP to allow the SNMP network management software, such as HP OpenView, to monitor the managed access points by using SNMPv1/v2 protocol. These settings are only applied only on ProSafe access points that support SNMP. Use the Group tab to select the settings for a specified group of access points. The access points that have not been assigned any group share the settings of Group 1. • Read-Only Community Name: The community string that allows the SNMP manager to read managed wireless access point MIB Objects. • Read-Write Community Name: The community string that allows the SNMP manager to read and write managed wireless access point MIB objects. • Trap Community Name: The community name of the IP address to receive traps. • IP Address to Receive Traps: The IP address at which the SNMP manager receives traps sent from managed wireless access points. • Trap Port: The port on which the SNMP manager receives traps sent from the managed wireless access points. The default setting is port 162. • SNMP Manager IP: Restrict access to specified SNMP manager for doing SNMP v1/v2. Set this to 255.255.255.255 to allow any SNMP manager to access. This setting is specific to WG103 access points, and is not applied to any other access point models. Click Apply to save the settings. Maintenance 54