Nikon S710  S710 User's Manual - Page 27
Removing the Battery, Turning On and Off the Camera, Auto Power-Off Standby Mode
UPC - 018208261277
View all Nikon S710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
First Steps Removing the Battery Turn the camera off and make sure that the power-on lamp and the monitor have gone out before opening the battery-chamber/memory card slot cover. To eject the battery, slide the orange battery latch in the direction shown 1. The battery can then be removed by hand 2. • Note that the battery may become hot during use; observe due caution when removing the battery. Inserting the Battery 1 2 Turning On and Off the Camera To turn on the camera, press the power switch. The power-on lamp (green) will light for a moment and the monitor will turn on. To turn off the camera, press the power switch again. When the camera turns off, both the power-on lamp and monitor will turn off. If the camera is turned off, hold down c to turn the camera on in playback mode. D Auto Power-Off (Standby Mode) • The monitor will dim to reduce the drain on the battery if no operations are performed for about five seconds. The monitor will brighten when camera controls are used. If no operations are performed for about a minute, the monitor will turn off automatically and the camera will enter standby mode. The camera will turn off automatically if no operations are performed for three minutes (Auto off). When the monitor is off in the standby mode, pressing the power switch or shutter-release button turns on the monitor. • The time allowed to elapse before the camera enters the standby mode can be changed from Auto off (A 127) in the setup menu (A 114). 15