NordicTrack 9600 El Trainr Elliptical Uk Manual - Page 23
Symptom: The Pedals Slip Or Give On The, Power Stroke Of Each Revolution, How To Replace The Battery
View all NordicTrack 9600 El Trainr Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
7. SYMPTOM: THE PEDALS SLIP OR GIVE ON THE POWER STROKE OF EACH REVOLUTION 7 If the pedals slip on the power stroke, the drive belt is slipping. You will need to adjust the tension of the drive belt. Remove the nine 1/4" x 3/4" Button Head Screws (59) from the Left Side Shield (6), and pivot the Left Side Shield to the side. 6 59 Remove the Right Side Shield (7) in the same way. 59 Note: For clarity, the left pedal disk is not shown. Rotate the pedal disk until the Drive Belt (15) is accessible. Loosen the four 1/4" x 3/8" Cap Screws (49 [only one is shown]). Tighten the Generator Tension Bolt (90) 1/4 turn until the Drive Belt (15) stops slipping. Retighten the four 1/4" x 3/8" Cap Screws, and secure the Left Side Shield with the nine 1/4" x 3/4" Button Head Screws (59). Secure the Right Side Shield (7) in the same way. 59 59 15 7 49 90 HOW TO REPLACE THE BATTERY PACK If you are replacing the Battery Pack (95), see the paragraph at the top of this page and pivot the left side shield to the side. Next, locate the Battery Pack (95). Disconnect the battery wire from the Lower Battery Wire (77). Cut the wire ties and discard the Battery Pack according to federal law. Reverse this step to attach the new Battery Pack (95). See the paragraph at the top of this page and reattach the left side shield. 22 Battery Wire 95 Wire Ties 77