NordicTrack E 5.5 Elliptical Canadian English Manual - Page 10

9. Attach the Rear Upright Cover (24) to the Upright (5) with four M4 x 16mm Screws (93). 9 93 5 24 10. Attach the Front Upright Cover (25) around the 10 Upright (5) by pressing the tabs on the Front Upright Cover into the Rear Upright Cover (24). 25 5 24 11. Identify the Short Pedal Arm Axles (115) and the Long Pedal Axles (not shown). Apply a small amount of grease to a Short Pedal Arm Axle (115) and to an M8 x 23mm x 1.5mm Washer (91). Next, partially tighten an M8 x 16mm Screw (102) and the M8 x 23mm x 1.5mm Washer (91) into one end of the Short Pedal Arm Axle (115). Orient a Pedal Arm (12) as shown. While a second person holds the end of the Right Pivot Arm (51) inside the bracket on the Pedal Arm, insert the Short Pedal Arm Axle (115) through both parts. Partially tighten another M8 x 16mm Screw (102) and an M8 x 23mm x 1.5mm Washer (91) into the Short Pedal Arm Axle (115). Then, tighten both Screws at the same time. Repeat this step on the other side of the elliptical. 11 102 91 Grease 115 51 12 91 102 10