NordicTrack E 5.5 Elliptical Canadian English Manual - Page 24

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. Next, locate the Reed Switch (69). Loosen, but do not remove, the M4 x 16mm Screw (93). To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING 93 69 74 If the console does not display your heart rate when 75 you hold the handgrip heart rate monitor, or if the dis- played heart rate appears to be too high or too low, see step 5 on page 19. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must 20 first remove the Top Shield (20). Using a flat screw- driver, release the tabs on the front and rear of the Top Shield and then remove the Top Shield. Next, rotate the Large Pulley (74) until a Magnet (75) is aligned with the Reed Switch (69). Slide the Reed Switch slightly toward or away from the Magnet. Then, retighten the M4 x 16mm Screw (93). Rotate the Large Pulley (74) for a moment. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the top shield. 24