NordicTrack Se 3i Instruction Manual - Page 9

7. Orient the Front Upright Cover (26) so that the word "UP" is at the top. 7 Attach the Front Upright Cover (26) to the Rear Upright Cover (25) with two M4 x 16mm Screws (78). 25 26 78 8. Using a plastic bag to keep your fingers clean, apply a generous amount of the included grease 8 to the axles on the Upright (2). Next, slide a Pivot Spacer (55) onto the right axle on the Upright (2). Then, identify the Right Upper Body Arm (10), orient it as shown, and slide it onto the right axle on the Upright. Attach the Right Upper Body Arm (10) with an M8 x 20mm Screw (84) and an M8 Washer (83). Repeat this step on the other side of the elliptical. 2 55 Grease 83 84 10 9. Identify the Right Rear and Front Arm Covers (20, 21), and orient them as shown. 9 Press the Right Rear and Front Arm Covers (20, 21) together around the Right Upper Body Arm (10), and attach them with two M4 x 16mm Screws (78). Tip: Attach the lower Screw first, and then attach the upper Screw. Repeat this step on the other side of the elliptical. 20 78 21 10 9