Oki ML490 ML490/491 User's Guide (American English) - Page 87

Testing the Printer

Get Oki ML490 PDF manuals and user guides View all Oki ML490 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 87 highlights

Testing the Printer • Font Sample Test • Rolling ASCII Test • Hexadecimal Dump Mode Font Sample Test The Font Sample Test prints a sample of the fonts standard to the printer. The top of the printout shows the Printer Model, Emulation, Country Code, Interface, and Firmware Revision Level. 1 Make sure paper is loaded. 2 Turn off the printer. 3 Press and hold the LF key while turning the printer back on. The printer prints a page of font samples and the test ends. Important! Wide carriage Model ML491: If you are using 8.5" paper to run the tests, make sure the paper width selection in the printer menu is set to 8.5 inches. Otherwise, printing on the platen may damage the printer. See Chapter 4: Menu Mode for more information. Installation 87

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
Installation
87
Testing the Printer
•
Font Sample Test
•
Rolling ASCII Test
•
Hexadecimal Dump Mode
Font Sample Test
Important!
W
ide car
r
ia
g
e Model ML491: If you are using 8.5" paper to
run the tests, make sure the paper width selection in the
printer menu is set to 8.5 inches. Otherwise, printing on the
platen may damage the printer. See Chapter 4: Menu Mode
for more information.
The Font Sample Test prints a sample of the fonts standard to
the printer.
The top of the printout shows the Printer Model, Emulation,
Country Code, Interface, and Firmware Revision Level.
1
Make sure paper is loaded.
2
Turn off the printer.
3
Press and hold the
LF
key while turning the printer back on.
The printer prints a page of font samples and the test ends.