Onkyo HTSP908 Owner Manual - Page 57

DV-SP405_En.book Page 57 Tuesday, May 29, 2007 2:48 PM Troubleshooting If you have any trouble using your DV-SP405, check the following table for possible causes and remedies. If you still can't resolve the issue yourself, please contact your Onkyo dealer. DVD Player Symptoms Can't turn on the DV-SP405? The disc tray won't close properly? Can't start playback? The picture distorts occasionally? Picture instability or noise? No picture? Settings are not saved? Causes The power cord is not connected. External interference is affecting the DV-SP405's digital circuitry. The disc is not centered in the disc tray. The disc is dirty. No disc is loaded. The disc cannot be played because it's incompatible. The disc is upside down. The disc is not centered in the disc tray. The disc is dirty. The disc uses parental lock and the "Parental Lock" function is on. The DVD-Video disc is intended for use in another region. The disc is dirty. You're using the Fast Forward or Fast Reverse function. The DV-SP405 is connected to your TV via a VCR or other video equipment and a copy-protection system is affecting the picture. The wrong input source is selected on your TV. The video cable is not connected properly. If there's a power failure, or the power cord is disconnected inadvertently, any settings are lost. New settings made in the Setup screen menus while a disc is playing are ineffective. Remedies Connect the power cord to a suitable wall outlet (page 24). Turn off the DV-SP405, wait five seconds, then try turning it on again. If that fails, disconnect the power cord from the wall outlet, wait five seconds, reconnect it, then try turning it on again. Place the disc in the center of the disc tray (page 27). Remove the disc and clean it (page 11). Load a disc (page 27). Use only compatible discs (page 8). Load the disc the correct way up (page 27). Place the disc in the center of the disc tray (page 27). Remove the disc and clean it (page 11). Turn off the "Parental Lock" function (page 48). If the region number on the disc does not match the region number on the DV-SP405, the disc can't be played (page 53). Remove the disc and clean it (page 11). A little picture distortion may occur when using these functions. This is normal. Connect the DV-SP405 directly to your TV (page 19). On your TV, select the input to which the DV-SP405 is connected. Check the video cable and correct as necessary (page 19). Before you disconnect the power cord, set the DV-SP405 to Standby by pressing the [STANDBY/ON] button, and wait until "OFF" has disappeared from the display. Some settings can be changed while a disc is playing, but are not effective until the disc is stopped then restarted: Press [STOP] button, then start playback again. 57