Onkyo TX-RZ830 Owners Manual - English - Page 168

Contents ≫ Connections ≫ Playback ≫ Setup ≫ ❏❏Playback sound is interrupted, or communication is not possible • You may not receive radio waves due to poor radio wave conditions. Shorten the distance from the wireless LAN router, or remove obstacles to improve visibility, and connect again. Install the unit away from microwave ovens or other access points. It is recommended to install the wireless LAN router and the unit in the same room. • If there is a metallic object near the unit, wireless LAN connection may not be possible because the metal affects the radio wave. • When other wireless LAN devices are used near the unit, other symptoms may occur, such as interrupted playback and impossible communication. You can avoid those problems by changing the channel of your wireless LAN router. For instructions on changing channels, refer to the instruction manual supplied with your wireless LAN router. • There may not be enough bandwidth available in wireless LAN. Use a wired LAN for connection. „„Multi-zone function (for compatible models only) ❏❏Cannot ZONE-output the audio of externally connected AV components • To output audio from an externally connected AV component to ZONE 2, connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or analog audio cable. Also, the audio from externally connected AV components can be output to ZONE 2 only when the audio is analog or 2ch PCM signal. When the AV component is connected to this unit with an HDMI cable, digital coaxial cable or digital optical cable, change the audio output of the AV component to the PCM output. • When video and audio via HDMI input are output to ZONE 2, set "1. Input/Output Assign" - "TV Out / OSD" - "Zone2 HDMI" ( p128) to "Use" on the Setup menu. • To output audio from an externally connected AV component to ZONE 3, use an analog audio cable for connection. Also, audio from externally connected AV components can be output to ZONE 3 only when it is an analog audio signal. ❏❏Others • If the audio signal is from the NET input selector, the zone output is not possible for DSD and Dolby TrueHD audio signals. „„Remote Controller • Make sure that the batteries are inserted with the correct polarity. • Insert new batteries. Do not mix different types of batteries, or old and new batteries. • Make sure that the sensor of the main unit is not subjected to direct sunlight or inverter-type fluorescent lights. Relocate it if necessary. • If the main unit is installed in a rack or cabinet with colored-glass doors, or if the doors are closed, the remote controller may not work normally. • After operating the Multi-zone function (for compatible models only), the remote controller mode may be switched to the mode for operating the ZONE output audio. Check "Multi-zone", and switch the remote controller mode to the mode for controlling the main room. ( p67) ( p98) 168 Front Panel≫ Rear Panel≫ Remote≫