Onkyo TX-RZ830 Owners Manual - English - Page 169

Contents ≫ Connections ≫ Playback ≫ Setup ≫ „„Display ❏❏The display does not light up • When the Dimmer function is working, the display may go dim or turn off (for compatible models only). Press the DIMMER button, and change the brightness level of the display. • The display is turned off when the Pure Audio (for compatible models only) listening mode is selected. „„Others ❏❏Strange noise can be heard from the unit • If you have connected another device to the same outlet as this unit, strange noise may occur under the influence of the device. If the symptom is remedied by removing the power plug of the other device from the outlet, use different outlets for this unit and the device. ❏❏The message "Noise Error" appears during AccuEQ Room Calibration • This can be caused by a malfunction in your speaker unit. Check the speaker output, etc. ❏❏The measurement results of AccuEQ Room Calibration show different distances to the speakers from the actual ones • Depending on the speakers you are using, some errors may occur in the measurement results. If this is the case, make the settings in "2. Speaker" - "Distance" in the Setup menu. ❏❏The measurement results of AccuEQ Room Calibration show that the volume level of the subwoofer has been corrected to the lower limit • The volume level correction of the subwoofer may not have been completed. Lower the volume of the subwoofer before AccuEQ Room Calibration measurement. ( p7) ( p134) 169 Front Panel≫ Rear Panel≫ Remote≫