Onkyo TX-SR393 AV Receiver Owners Manual - English - Page 68
Distance, Setting Item, Default Value, Setting Details
View all Onkyo TX-SR393 AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ Setting Item Surround LPF of LFE Double Bass Default Value 100 Hz 120 Hz On Setting Details Select the crossover frequency from "40 Hz" to "200 Hz" to start outputting frequencies for each channel. "Full Band": Full band will be output. • "Full Band" can be selected only when "Front" is set to "Full Band". • If the item cannot be selected even though connection is correct, check if the setting in "Configuration" - "Speaker Channels" matches the number of connected channels. Set the low-pass filter for LFE (low-frequency effect) signals in order to pass only the lower frequency signals than the set value, and thus cancel unwanted noises. The low-pass filter is effective only on sources with LFE channel. The value from "80 Hz" to "120 Hz" can be set. "Off": When this function is not used This can be selected only when "Configuration" - "Subwoofer" is set to "Yes" and "Front" is set to "Full Band". Bass output is boosted by feeding bass sounds from the front right and left, and center speakers to the subwoofer. "On": Bass output is boosted. "Off": Bass output is not boosted. • This function is not automatically set even if AccuEQ Room Calibration is performed. 3. Distance Set the distance from each speaker to the listening position. Setting Item Front Left Center Front Right Height Left Height Right Surround Right Surround Left Subwoofer Default Value 12.0 ft/3.60 m 12.0 ft/3.60 m 12.0 ft/3.60 m 9.0 ft/2.70 m 9.0 ft/2.70 m 7.0 ft/2.10 m 7.0 ft/2.10 m 12.0 ft/3.60 m Setting Details Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. • Default values vary depending on the regions. • The unit of distance can be changed by pressing the MODE button on the remote controller. When using the unit "feet", the setting is available in increments of 0.1 ft from 0.1 ft to 30.0 ft. When using the unit "meter", the setting is available in increments of 0.03 m from 0.03 m to 9.00 m. 68 Front Panel≫ Rear Panel≫ Remote≫