Onkyo TX-SR393 AV Receiver Owners Manual - English - Page 75

Contents ≫ Connections ≫ Playback ≫ Setup ≫ Setting Item Pairing Information Device Status Default Value - - Setting Details You can initialize the pairing information stored on this unit. Pressing ENTER when "Clear" is displayed initializes the pairing information stored on this unit. • This function does not initialize the pairing information on the BLUETOOTH-enabled device. When pairing the unit again with the device, be sure to clear the pairing information on the BLUETOOTH-enabled device beforehand. For information on how to clear the pairing information, refer to the instruction manual of the BLUETOOTH-enabled device. Displays the name of the BLUETOOTH-enabled device connected to the unit. • The name is not displayed when "Status" is "Ready" and "Pairing". Displays the status of the BLUETOOTH-enabled device connected to the unit. "Ready": Not paired "Pairing": Paired "Connected": Successfully connected • Wait for a while if "Bluetooth" cannot be selected. It can be selected when the BLUETOOTH function is activated. „„3. Power Management Change the settings for the power-save function. Setting Item Sleep Timer Default Value Off Setting Details You can allow the unit to enter standby automatically when the specified time elapses. Select a value from "30 minutes", "60 minutes" and "90 minutes". "Off": The unit does not automatically enter standby mode. Setting Item Auto Standby Auto Standby in HDMI Standby Through USB Power Out at Standby Default Value On/Off Off Off Setting Details This setting allows the unit to enter standby mode automatically after 20 minutes of inactivity without any video or audio input. (When "USB Power Out at Standby" is enabled, the unit enters the HYBRID STANDBY mode which minimizes the increase in power consumption.) "On": The unit automatically enters standby mode ("AUTO STBY" lights up). "Off": The unit does not automatically enter standby mode. • "Auto Standby" is displayed on the main unit's display and TV screen 30 seconds before entering standby mode. • Default values vary depending on the regions. Enable or disable "Auto Standby" while "HDMI Standby Through" is on. "On": The setting is enabled. "Off": The setting is disabled. • This setting cannot be set to "On" if "Auto Standby" and "HDMI Standby Through" are set to "Off". When this function is set to "On", electricity can be supplied to the device connected to the POWER OUT port even if this unit is in standby mode . • While using this function, power consumption increases in standby mode, however, the increase in power consumption is minimized by automatically entering the HYBRID STANDBY mode where only the essential circuits are operating. 75 Front Panel≫ Rear Panel≫ Remote≫