Optoma HD83 User's Manual - Page 17

Powering On/Off the Projector

Get Optoma HD83 PDF manuals and user guides View all Optoma HD83 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Installation Powering On/Off the Projector Powering On the Projector . Remove the lens cap.  2. Securely connect the power cord and signal cable. When con- nected, the Power LED will turn red. 3. Turn on the lamp by pressing " " button on the side of the projec- tor or on the remote control. The Power LED will flash blue.  The startup screen will display in approximately 30 seconds. The first time you use the projector, you can select your preferred language from quick menu after the startup screen display. 4. Turn on your source that you want to display on the screen (computer, notebook, video player, etc). The projector will detect the source automatically and will display on the screen. If not, push menu button and go to "SETUP". Make sure that the "Source Lock" has been set to "Off".  If you connected multiple sources at the same time, press the "Source" key on the remote control to switch between inputs. 1 NOTE  Turn on the STANDBY projector first and then select the signal sources. 2 POWER LAMP TEMP STANDBY 7 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
English
±7
Installation
POWER
TEMP
LAMP
STANDBY
Powering On the Projector
±. Remove the lens cap.
2. Securely connect the power cord and signal cable. When con-
nected, the Power LED will turn red.
3. Turn on the lamp by pressing
“
”
button on the side of the projec-
tor or on the remote control. The Power LED will flash blue.
The startup screen will display in approximately 30 seconds. The
first time you use the projector, you can select your preferred lan-
guage from quick menu after the startup screen display.
4.
Turn on your source that you want to display on the screen (com-
puter, notebook, video player, etc). The projector will detect the
source automatically and will display on the screen. If not, push
menu button and go to “SETUP”. Make sure that the “Source
Lock” has been set to “Off”.
If you connected multiple sources at the same time, press the
“Source” key on the remote control to switch between inputs.
Turn on the
projector first and
then select the
signal sources.
1
2
N
OTE
Powering On/Off the Projector