Optoma HD83 User's Manual - Page 49
Lamp Replacing Procedure, To replace the lamp module, reverse the previous steps.
View all Optoma HD83 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Appendices 1 2 3 4 Lamp Replacing Procedure: 1. Switch off the power to the projector by pressing the Power button. 2. Allow the projector to cool down at least 30 minutes. 3. Disconnect the power cord. 4. Unlock the lamp cover. 5. Push up and remove the cover. 6. Use a screwdriver to remove the screw from the lamp module. 7. Pull out the lamp module. To replace the lamp module, reverse the previous steps. 8. Turn on the projector and do "Lamp Reset" after the lamp module is replaced. Lamp Reset: (i)Press "Menu" -> (ii)Select "System" -> (iii)Select "Lamp Settings" ->(iv)Select "Lamp Reset" -> (v)Select "Yes". 49 English
English
49
Appendices
Lamp Replacing Procedure:
±.
Switch off the power to the projector by pressing the Power button.
2.
Allow the projector to cool down at least 30 minutes.
3.
Disconnect the power cord.
4.
Unlock the lamp cover.
5.
Push up and remove the cover.
6.
Use a screwdriver to remove the screw from the lamp module.
7.
Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
8.
Turn on the projector and do “Lamp Reset” after the lamp module is
replaced.
Lamp Reset: (i)Press “Menu” -> (ii)Select “System” -> (iii)Select “Lamp
Settings” ->(iv)Select “Lamp Reset” -> (v)Select “Yes”.
2
4
3
1