Panasonic 26PEK1U6 Tech Data - Service Manual - Page 112

1. Specifications CAUTION If the signal receiving unit is installed near a rapid-start or inverter type fluorescent lamp (neither one uses glow lamps), it may be impossible to receive signals from the wireless remote controller. To avoid signal interference from fluorescent lamps, install the receiving unit at least 6.6 ft. away from the lamps and install at a location where wireless remote controller signals can be received when the fluorescent lamps are on. 7-12. Separate Type Signal Receiving Unit Installation CAUTION Do not twist the operating controller wires together with the power supply wires. Doing so can result in malfunction. If electrical noise is induced in the unit power supply, take appropriate measures, for example installing a noise filter. 1 If local electrical codes allow, this signal receving unit can be mounted using a conventional wall box for flush mounting. (1) If Wall mounted Fixed Position Install the remote controller at a convenient location on a nearby wall. However, before attaching the remote controller mounting cradle, check that the remote controller can operate from the desired wall position. (Fig. 1-97) How to Install Batteries See Fig. 1-98. (1) Press and slide the lid on the back of the remote controller in the direction of the arrow. (2) Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment. (3) Press the reset hole, then replace the lid. If you press it, the current time, ON time, and OFF time are all reset to 0:00. Signal receiving unit M4 × L1" Screws (2) Spacer ALL• RCU PCB TEST : SUB CHK. RUN RNCOURM: MALAIN 123 ADR 456 Notch Cover plate Fig. 1-96 Switch box (no cover) Fasten the remote control mount with screws. Fitting the remote control in the mount. 2 Press 1 Put in Remote control mount Fig. 1-97 Reset hole Cover Fig. 1-98 1-106