Panasonic 26PEU1U6 Installation Instructions - Page 22

3-12. Installing the Rear Panel on the Wall Be sure to confirm that the wall is strong enough to suspend the unit. See either Item a) or b) below depending on the wall type. a) If Wooden Wall (1) Attach the rear panel to the wall with the 10 screws provided. (Fig. 3-25) If you are not able to line up the holes in the rear panel with the beam locations marked on the wall, use toggle bolts to go through the holes on the panel or drill 3/16" dia. holes in the panel over the stud locations and then mount the rear panel. (2) Double-check with a ruler or level gauge that the panel is level. This is important to install the unit properly. (Fig. 3-26) (3) Make sure the panel is flush against the wall. Any space between the wall and unit will cause noise and vibration. b) If Block, Brick, Concrete or Similar Type Wall Make 3/16" dia. holes in the wall. Insert rawl plugs for appropriate mounting screws. (Fig. 3-27) Fig. 3-25 Fig. 3-26 1-3/16" or more 3/16" dia. hole Rawl plug (Field supply) Fig. 3-27 22 1BOBTPOJD@1"$J@*OEPPS6OJU@64MF