Panasonic 3-MOS P2 Hand-held Camcorder Advanced Operating Instructions - Page 52

Switching audio input During shooting, you can record up to four channels of sound. You can also switch the input sound to be recorded on each of the channels to the built-in microphones, external microphones or audio equipment connected to camera-recorder. (See table below.) CH1 SELECT switch INT (L) INPUT1 INPUT2 CH1 recording CH3 recording Built-in microphone Lch INPUT1 switch selection is valid (LINE/MIC select) INPUT2 switch selection is valid (LINE/MIC select) INPUT1 switch selection is valid (LINE/MIC select) Built-in microphone Lch Built-in microphone Lch CH2 SELECT switch INT (R) INPUT2 CH2 recording CH4 recording Built-in microphone Rch INPUT2 switch selection is valid (LINE/MIC select) INPUT2 switch selection is valid (LINE/MIC select) Built-in microphone Rch However, the following restrictions apply depending on the format used. • Refer to the section "Recording format list" (Page 164) recording format. When the AVC-I100, AVC-I50, DVCPROHD or DVCPRO50 format is used: The recording mode is fixed at 4-channel recording. When the DVCPRO or DV format is used: Either 2 or 4 channels can be selected using 25M REC CH SEL on the setting menu AUDIO SETUP screen. INPUT1 LINE/MIC switch INPUT1 switch (MIC POWER +48V) INPUT2 LINE/MIC switch INPUT2 switch (MIC POWER +48V) AUDIO CH2 SELECT switch AUDIO CH1 SELECT switch AUDIO INPUT 1/2 terminal Using the built-in microphone 1 Switch the AUDIO CH1 SELECT switch to INT (L). • Audio from the built-in microphone Lch is recorded to audio channel 1. 2 Switch the AUDIO CH2 SELECT switch to INT (R). • Audio from the built-in microphone Rch is recorded to audio channel 2. 52