Panasonic AE3000U Operating Instructions - Page 24

Basic Operation Remote control operation Loading a saved setting You can access saved settings instantly. See "MEMORY LOAD" on page 36. 1. Select the required setting from MEMORY1 - 16. Undefined setting will not be displayed. 2. Press the ENTER button to activate the selected setting. NOTE: • If you have not saved any settings, MEMORY1 - 16 will not be displayed. Switching the aspect ratio The aspect ratio will be selected automatically, or you can switch it manually by pressing the ASPECT button. Press the button several times to cycle through the different aspect type as follows. See "ASPECT" on page 37. Q VIDEO/S-VIDEO/COMPONENT (YPBPR) 4:3 JUST 16:9 ZOOM2 14:9 Q COMPUTER (RGB) 4:3 ZOOM1 16:9 Q HDMI 4:3 16:9 NOTE: • If you project an image with an unmatched aspect ratio, the image may distort or some portions may be cropped. Select an aspect ratio which preserves the intention of the image creator. • The order of aspect type is defined not only by the input method but also by the input signals. See "List of compatible signals" on page 50. • If you project a copyrighted image enlarged or distorted by using ASPECT function in commercial use in a public place, such as a restaurant or hotel, you might infringe on the copyright of the creator which is protected by copyright law. Adjusting the signal condition with a waveform You can display the image brightness and contrast level of the input signal with a waveform. See "WAVEFORM MONITOR" on page 33. FULL SCAN Monitoring the waveform of brightness and contrast of the whole image. Monitoring the waveform of SINGLE LINE SCAN brightness and contrast in each horizontal line of the image. J Displaying the waveform 1. Press the WAVEFORM button and display the waveform monitor. Press the WAVEFORM button again to escape from the waveform mode. 2. Press ENTER button until the required waveform option is displayed. In FULL SCAN mode, press F G I H to change the waveform position. In SINGLE LINE SCAN mode, press F G to select the required line position. FULL SCAN(Y) SINGLE LINE SCAN(B) FULL SCAN(R) SINGLE LINE SCAN(G) FULL SCAN(G) SINGLE LINE SCAN(R) FULL SCAN(B) SINGLE LINE SCAN(Y) NOTE: • In SINGLE LINE SCAN mode, the position of the waveform monitor depends on the position of the selected line. • You can display the main menu by pressing the MENU button and adjust the menu items. • The called up menu items displayed position depends on the position of the waveform monitor. • You can activate AUTO ADJUST of the WAVEFORM menu by pressing the DEFAULT button. • The signal which is lower than 0% in the waveform will be displayed as same as 0% on the projected image. • While the waveform is displayed, the image is displayed without the COLOR MANAGEMENT adjustment. • When adjusting the KEYSTONE of the POSITION menu while the waveform is displayed, x.v.Color will be deactivated. 24 - ENGLISH