Panasonic AE3000U Operating Instructions - Page 51
Serial terminal, Technical Information, Connection, Pin assignments and signal names
UPC - 791871111741
View all Panasonic AE3000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Technical Information Serial terminal The serial connector which is on the connector panel of the projector conforms to the RS-232C interface specification, so that the projector can be controlled by a personal computer which is connected to this connecter. J Connection D-sub 9 pin (male) Serial terminal (female) Computer NOTE: • You must use only an RS-232C Serial Interface Cable with a ferrite core, type ET-ADSER. J Pin assignments and signal names Pin No. A B C D E F G H I J Cable specifications (When connected to a personal computer) Signal name TXD RXD GND RTS CTS NC NC Projector NC Contents NC Transmitted data Received data NC Earth NC Connected internally NC NC NC PC (DTE) NC J Basic format NC NC STX Start byte (02h) Command : Parameter 3 bytes 1 byte 1 byte 4 bytes ETX End (03h) The data streaming from the computer will start with STX, and proceed to Command, Parameter and end with ETX. You can add the required parameter. The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds before sending the command. If sending multiple commands, check that a response has been received from the projector for one command before sending the next command. When a command which does not require parameters to be sent, the colon (:) is not required. If an incorrect command is sent from the personal computer, the ER401 command will be sent from the projector to the personal computer. ENGLISH - 51 Appendix