Panasonic AE3000U Operating Instructions - Page 46
Care and Replacement, Cleaning the projector - replace lamp
UPC - 791871111741
View all Panasonic AE3000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Care and Replacement Cleaning the projector J Before cleaning the projector Switch off the MAIN POWER switch in proper way and disconnect the power plug from the wall outlet. Unplug all the cables from the projector. J Cleaning the outer surface of the projector Wipe off dirt and dust gently with a soft cloth. If it is difficult to remove the dirt, soak a cloth in water, wring the cloth well and then wipe the projector. Dry off the projector with dry cloth. Do not use petroleum benzine, thinner, any alcoholic solvent, kitchen detergents or chemical clothes. Failure to observe these may result in altered or damaged surface of the projector. J Cleaning the lens surface Wipe off dirt and dust gently with a lint-free cloth. Make sure no dirt or dust remains on the surface of the lens. It will be enlarged and projected onto a screen. J Cleaning the air filter If the air filter is excessively dirty, the internal temperature of the projector increases and may cause malfunction. Clean the air filter regularly every 100 hours of usage. 1. Place a finger at the bottom of the air filter. 2. Slightly push up and pull out the air filter to remove. 3. Vacuum dirt and dust from the air filter. Do not wash the air filter. 4. Place and slightly slide in the air filter in the air intake port to attach. Make sure the air filter clicks into the place. NOTE: • Do not use the projector without attaching the air filter. J Replacing the air filter The air filter should be replaced when cleaning is ineffective and when replacing the lamp unit. A replacement air filter (TXFKN01VKF5) is provided with a replacement lamp unit, ET-LAE1000. Contact an Authorized Service Center for the optional air filter. 46 - ENGLISH Maintenance