Panasonic AW-HE38H Operating Instructions - Page 16
Preset memories
View all Panasonic AW-HE38H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Preset memories The unit enables up to 100 settings for the camera direction (panning and tilting), zoom, focus, iris, gain and white balance to be registered in its preset memories, and called. However, the number of settings that can be registered and called depends on the type of wireless remote control or controller that is used for operation. ●● The focus and iris operating modes (manual and auto settings) are not registered. The current focus and iris values are registered. ●● The focus and iris values can be recalled only when the manual settings are applicable. ●● AWB A, AWB B, ATW, 3200K, 5600K or VAR is registered as the white balance setting. The values selected when AWB was established are recalled as the adjustment values of AWB A or AWB B. Notes ●● When there is a large difference in the environmental temperature between the time of registration and the time the setting is called, displacement of the preset position may occur. ●● When recalling a preset with a different image stabilization setting from when the preset was registered, displacement in the zoom position may occur. ●● If displacement occurs, perform registration again. ●● Manual operations, such as pan, tilt, zoom, and iris control, can be performed while the recalling of a preset is in progress. However, the preset actions will be canceled. ●● If a preset is recalled while the recalling of another preset is in progress, the current preset actions are canceled, and the newly selected preset is recalled. ●● Nothing will occur if a preset memory number to which a preset has not been registered is recalled. When performing the operations using the wireless remote control Twelve settings (preset No.1 to No.12) can be registered and called using the wireless remote control. The [1] to [12] buttons correspond to the unit's preset memories No.1 to No.12. ●●Registering the settings in the preset memories 1 Display the picture to be shot on the monitor. Operate the pan, tilt or zoom buttons to determine the camera angle. Adjust the focus, iris, gain and white balance if they need to be adjusted. 2 While holding down the [PRESET] button, press the button corresponding to the preset memory number. ●● If a preset memory number with an already registered setting has been selected, the existing setting will be erased and replaced with the new one. ●●Calling the settings of the preset memories 1 Press the button in which the preset memory setting has been registered. When performing the operations using the controller When using an AW-RP50 or AW-RP120: Up to 100 entries can be registered/recalled. For details, refer to the operating instructions for the controller. 16