Panasonic AW-HE38H Operating Instructions - Page 22

Basic operations Camera menus are displayed on the monitor when the unit's settings are to be selected. The monitor is connected to the video signal output connector. The basic camera menu operations involve displaying sub‑menus from the Top Menu items, and selecting settings on the sub‑menus. Some sub‑menus have menu items for performing more detailed settings. The camera menu operations are conducted using the wireless remote control. If a controller is connected, they can also be conducted using the controller. Note ●● Check that your controller is the following version. AW-RP50: Ver 3.10.00 or later AW-RP120: Ver 2.10.00 or later AK-HRP200: Ver 4.10-00-0.00 or later If the version older, an upgrade is required. For details on upgrading, visit the support page on the following website. http://pro-av.panasonic.net/ Described below are the basic operations for changing the camera menu item settings using the wireless remote control and controller (AW‑RP50, AW-RP120 or AK-HRP200). Only the steps taken using the wireless remote control will be described here for the operations conducted to select and set the items. For details of the operations conducted using the controller, substitute "controller" for "wireless remote control" when reading the basic operations. Also, refer to the Operating Instructions of the controller. Table of operations Camera menu operation Wireless remote control Selecting the unit to be Press the [CAM1], [CAM2], [CAM3] operated or [CAM4] button. Displaying the Top Menu Press the [MENU] button for 2 seconds. Selecting the items Press the [▲] or or [►]) button. Displaying the sub‑menus Press the [○] button. Returning to the previous menu With the cursor at the "Return" position, press the [○] button. Changing the settings With the cursor at the item to be changed, press the [○] button to start the item's value blinking. Use the and [►] buttons to change the value, and press the [○] button to enter the change. Canceling the setting change While the setting is blinking, press the [MENU] button quickly (for less than 2 seconds). Controller AW‑RP50 AW-RP120 AK-HRP200 Press one of the [CAMERA STATUS/SELECTION] buttons. 1. Press and hold the [SELECT] button for about 2 seconds.  The camera number in the camera number display area blinks. 2. Press the lit [UP]/[DOWN] button.  Press the lit [UP]/[DOWN] button to select the camera number. 3. Press the [SELECT] button.  Control of the selected camera is enabled. Press the [CAMERA OSD] button for Press and hold the [CHARA/MENU] 2 seconds. button for about 2 seconds. Turn the F1 dial. Turn the SELECT dial. Press the F1 dial. With the cursor at the "Return" position, press the F1 dial. 1. Press the F1 dial to start the setting blinking. 2. Turn the F1 dial to change the setting. 3. Press the F1 dial to enter the setting (and stop the blinking). Press the SELECT dial. With the cursor at the "Return" position, press the SELECT dial. 1. Press the SELECT dial to start the setting blinking. 2. Turn the SELECT dial to change the setting. 3. Press the SELECT dial to enter the setting (and stop the blinking). - - 22