Panasonic AW-HE38H Operating Instructions - Page 82

Web screen configurations (continued) Control pad and its buttons To adjust the image in the horizontal or vertical direction (panning or tilting), leftclick the pad and the buttons. The more the outside of the pad is clicked, the faster the camera operates. Adjustment is also possible by dragging the mouse. Right-click the pad to initiate zooming and focusing. When the top half of the pad is clicked in the up or down direction, the zoom (magnification) is adjusted in the Tele direction; conversely, when the bottom half of the pad is clicked, the zoom is adjusted in the Wide direction. When the left half of the pad is clicked in the left or right direction, the focus is adjusted in the Near direction; conversely when the right half of the pad is clicked, the focus is adjusted in the Far direction. The zooming can also be adjusted by operating the mouse wheel. Note ●● When the mouse is used for dragging and dropping from the control pad area to a position outside this area, the panning, tilting and other operations will not stop. In a case like this, click the control pad area to stop these operations. Speed Use this to select the speed at which the pan, tilt, zoom and focus operations are to be performed. Speed With Zoom POS. "Off" or "On" is set here for the function used to adjust the pan-tilt adjustment speed in conjunction with the zoom magnification. Setting value: Off The panning and tilting operations will not become slower in the zoom status. On The panning and tilting operations will become slower in the zoom status. Factory settings: On This function has no effect during preset operations. Focus ADJ With PTZ. "Off" or "On" is set here for the function which compensates for out-of-focusing when it occurs during panning, tilting or zooming operations. Factory settings: Off When "Off" is set, adjust the focus as required after zooming or set the focus to the auto mode. This item can be selected only when "Manual" has been selected as the "Focus Mode" setting. Preset Setting Preset Speed Table Set the preset speed table (Slow, Fast). During preset playback, preset actions are performed at Preset Speed (1 to 30) values that are based on the table set here. Setting value: Slow Set the preset speed table to "Slow". Fast Set the preset speed table to "Fast". Factory settings: Fast Preset Speed There are 30 preset pan-tilt operation speeds when regenerating the camera direction and other information which are registered in the preset memory. Setting range: 1 to 30 Factory settings: 10 Note ●● If a high value is selected for the Preset Speed setting, the image on the screen may shake when operation stops. Preset Scope Selected here are the setting items to be recalled when the contents of the preset memory are regenerated. Setting value: Mode A Pan, Tilt, Zoom (including digital zoom), Focus, Iris, Gain, white balance adjustment value Mode B Pan, Tilt, Zoom (including digital zoom), Focus, Iris Mode C Pan, Tilt, Zoom (including digital zoom), Focus Factory settings: Mode A Limitation Setting This establishes the up, down, left and right limit settings of the pan-tilt head. First, move the pan-tilt head to the position where the limit is to be set, and press the corresponding button below to set the direction (up, down, left or right) in which the limit is to be set. After each setting has been selected, press the [Set] button to enter the setting. Tilt Up Use this to save the current position as the upward limit. Tilt Down Use this to save the current position as the downward limit. Pan Left Use this to save the current position as the leftward limit. Pan Right Use this to save the current position as the rightward limit. Set/Release Use this to enable or disable the limit setting in each direction. When the [Set/Release] button is pressed, the tally lamp of the unit blinks. When a limiter is set, it blinks once; when a limiter is released, it blinks twice. 82