Panasonic AW-HS50 Operating Instructions - Page 23

1. Basic operations 1-7. Switching the AUX output 1-7-1. Selecting the AUX bus material The AUX output material is selected using the A bus and B bus crosspoint buttons. 1 Press the AUX button to set the crosspoint buttons to the AUX bus material selection mode. The indicator of the AUX button blinks. 2 Select the material using the A bus or B bus crosspoint buttons. [A bus crosspoint buttons] When buttons [1], [2], [3], [4] and [5] are pressed, PGM, PVW, KEY OUT, CLN or MV are selected, respectively. [B bus crosspoint buttons] When the buttons from [1] to [5] are pressed, the materials assigned to the corresponding XPT1 to XPT5 are selected. When the button from [1] to [5] are pressed while the SHIFT button is held down, the materials assigned to the corresponding XPT6 to XPT10 are selected. 3 Press the AUX button to release the bus selection mode for the crosspoint buttons. 1, 3 2 1-7-2. Transitions between AUX materials When an AUX bus material has been selected, the effect to be produced when images are switched can be executed as a MIX transition. (Bus transition function) [1] TIME/CBGD Menu 6. AUX BUS Trans Set the transition duration, and set the bus transition function to "Enable" or "Disable". While the transition is underway, the indicator of the transition source button lights, and the indicator of the transition destination button blinks. When the transition is completed, the indicator of the transition source button goes off, and the indicator of the transition destination button lights. When another signal has been selected while a transition is underway, the processing for the transition will continue from the interim point. AUX PinP KEY-F/S BUS DELEGATION MIX WIPE TRANSITION TYPE PinP ON KEY ON FTB ON KEY-S AUX PGM 16 KEY-F PinP AUX PVW 27 KEY OUT 38 CLN 49 MV 5 10 A SHIFT B SHIFT CUT AUTO BKGD 23