Panasonic PVGS55 PVGS55 User Guide - Page 15

Before Use ≥Insert the plug securely into the [REMOTE] Jack as far as it will go. A loose connection will affect normal operation. The Remote Controller ª Using the Remote Controller 1 Direct the Remote Controller at the Remote Control Sensor (33) of the Palmcorder and press an appropriate button. ª Inserting a Button-type Battery Before using the Remote Controller, insert the supplied button-type battery. 1 While pressing the Lock Button 1, pull out the Battery Holder. 1 2 Insert the button-type battery with the (i) marking facing upwards. 3 Insert the Battery Holder into the Remote Controller. ≥When the button-type battery is exhausted, replace it with a new CR2025 battery. (A battery is normally expected to last about 1 year. However, it depends on operation frequency.) ≥Make sure to match the poles correctly when inserting the battery. Warning Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer's instructions. Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212°F (100°C) or incinerate. Keep the Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed, call your doctor. Replace battery with Panasonic PART NO. CR2025 only. Use of another battery may present a risk of fire or explosion. Caution: Battery may explode if mistreated. Dispose of used battery promptly. Keep away from children. Do not recharge, disassemble or dispose of in fire. 15˚ 15˚ (33) 15˚ 15˚ ≥Distance from the Palmcorder: Within approximately 15 feet (5 meters) ≥Angle: Approximately 15o in the vertical and horizontal directions from the central axis ≥The above operating ranges are for indoor use. Outdoors or under strong light, the Palmcorder may not operate properly even within the above ranges. ≥Within a 3 feet (1 meter) range, you can also use the Remote Controller on the LCD Monitor side of the Palmcorder. Selecting Remote Controller Modes When 2 Palmcorders are used simultaneously, they can be operated individually by selecting different Remote Controller Modes. ≥If the Remote Controller Mode of the Palmcorder and that of the Remote Controller do not match, [REMOTE] Indication is displayed. Setup on the Palmcorder: Set [REMOTE] on the [INITIAL] Sub-Menu to the desired Remote Controller ModeT . (-22-) Setup on the Remote Controller: W 61 5 STILL ADV PAUSE STILL ADV 2 E ; D 1 INDEX STOP INDEX P.B. ZOOM K ∫ L SELECT [VCR1]: Press the [D] Button and [∫] Button simultaneously. 1 [VCR2]: Press the [E] Button and [∫] Button simultaneously. 2 ≥When the battery in the Remote Controller is replaced, the mode is automatically reset to [VCR1] Mode. -15-