Pfaff hobbylock 2.5 Owner's Manual - Page 13

Threading the lower looper (yellow) 1 • Raise the presser foot to release tension discs. • Pass the thread from back to front through the thread guide on the thread stand (1). • Thread the top cover thread guide by pulling the thread towards the right until it slips under the guide. Then pull the thread along the right side of the button as illustrated (2). 3 • Lift up the handle and bring the thread under it. While holding the thread with both hands, pass it between the tension discs and pull it down to make certain it is properly placed between the tension discs (3). 2 1 2 • Turn the handwheel toward you until the lower looper extends out 10 mm (3/8") from the needle plate edge. • Thread the looper area of the machine following the yellow color coded thread guides (4-10). 10 9 4 5 • To thread the last thread guide (9), pull about 10 cm (4") of thread through the guide (8). Tip: Moving the stitch finger lever to R makes the threading easier. Remember to set it back to N before starting to sew. • Thread the looper eye (A) from front to back using the tweezers. Make sure the thread runs into the "V" cutouts (B) on threader lever. Firmly hold the thread tail with left hand and pull the threader lever (C) up into place and back to snap the thread into thread guide 9. 8 9 B 7 6 A C Threading 13