Pfaff hobbylock 2.5 Owner's Manual - Page 14

Threading the right needle 1 (green, B on needle clamp) • Raise the presser foot to release tension discs. • Pass the thread from back to front through the thread guide on the thread stand (1). • Thread the top cover thread guide by pulling the thread towards the right until it slips under the guide. 3 Then pull the thread along the right side of the button as illustrated (2). • Lift up the handle and bring the thread under it. While holding the thread with both hands, pass it between the tension discs and pull it down to make certain it is properly placed between the tension discs (3). 2 1 2 • Continue to thread points (4-8). • Slip the thread into the rear slot on the thread guide (5) and into the slot on the take-up lever cover (6). Then slip the thread into the right slot on the thread guides (7) and (8). • Before threading the eye of the needle, make sure the thread is behind the thread guide located on the bottom of the needle clamp. • Thread the eye of the needle (9). Use the needle threader (see page 16) to make needle eye threading easier. • Pull about 10 cm (4") of thread through needle eye to hang free. • Place the thread to the back, under the presser foot. 14 Threading 6 4 5 7 8 9 9