Philips LC3136 User Manual - Page 30

6. Maintenance < Lamp replacement B 5 Unscrew screw B. 6 Grasp the lamp holder handle and carefully pull the lamp holder out of the projector. • Do not tilt. If the inner tube is broken glass particles may fall out. • Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening at anyone. 7 Carefully remove the new lamp housing from its package. • Always use the same type of lamp: See 'Optional accessories' for the correct type of lamp for your projector. • Do not touch lamp or point lamp housing opening at anyone. • Do not drop, as the impact may cause the lamp to break. 8 Place the lamp holder in the guiding slots and insert into the lamp compartment. 9 Tighten screw B again. B 10 Put the lamp door back in place and press tab A back in its original position. - The Mains inlet socket will open again. 11 Insert the mains lead into both the projector Mains inlet socket and the wall socket. 12 Press the Standby button to switch on the projector. A 13 Reset the lamp life time (see 'Resetting the lamplife time'). 14 Dispose of the old lamp in special chemical disposal bins. Resetting the lamplife 1 Press Menu. time - The menu bar appears on the screen. AV Mute Stand by Source Lamp Temp Menu OK Display Picture (previous) Start-up screen Lamp counter Auto standby Auto source Feedback Audio Settings Lamp 0 hours Lamp counter shows the operating hours of the lamp. It is suggested to reset when a new lamp is inserted. To reset keep OK key pressed for 3 seconds. 2 Use cursor control to select 'Settings' in the menu bar. 3 Use cursor control to select 'Lamp counter' in the sub menu. 4 Press OK for 3 seconds to reset the lamp counter. 5 If required, select another item you wish to adjust or press Menu to exit. Philips Multimedia Projector 30 English User guide bSure1 / bSure 2