Pioneer DEH P410UB Owner's Manual - Page 8

Section 01 Before You Start 2 Grab the front panel and remove. Attaching the front panel 1 Slide the front panel to the left until it clicks. Front panel and the head unit are jointed on the left side. Make sure that the front panel has been jointed to the head unit. 2 Press the right side of the front panel until it is firmly seated. # If you can't attach the front panel to the head unit successfully, try again. Front panel may be damaged if you attach the front panel forcedly. unit, connected device or vehicle interior may be damaged. Feature demo mode The feature demo automatically starts when power to this unit is turned off while the ignition switch is set to ACC or ON. Press DISP during feature demo operation to cancel the feature demo mode. Press DISP again to start. Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power. Use and care of the remote control Installing the battery Slide the tray on the back of the remote control out and insert the battery with the plus (+) and minus (-) poles aligned properly. ! When using for the first time, pull out the film protruding from the tray. About the demo mode This unit features the feature demo mode. Important ! The red lead (ACC) of this unit should be connected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained. ! Before detaching, be sure to remove the AUX cable from the front panel. Otherwise, this WARNING Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor immediately. CAUTION ! Use one CR2025 (3 V) lithium battery. ! Remove the battery if the remote control is not used for a month or longer. ! There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type. ! Do not handle the battery with metallic tools. ! Do not store the battery with metallic objects. 8 En