Pioneer DEH-X7500S Owner's Manual - Page 26

Section 04 Installation Installation Removing the unit 1 Remove the trim ring. Securing the front panel The front panel can be secured with the supplied screw. 1 1 Trim ring 2 Notched tab ! Releasing the front panel allows easier ac- cess to the trim ring. ! When reattaching the trim ring, point the side with the notched tab down. 2 Insert the supplied extraction keys into both sides of the unit until they click into place. 3 Pull the unit out of the dashboard. 1 Screw Removing and re-attaching the front panel You can remove the front panel to protect your unit from theft. Press the detach button and push the front panel upward and pull it toward you. For details, refer to Removing the front panel to protect your unit from theft and Re-attaching the front panel on page 5. Installing the microphone Only for DEH-X8500BH and DEH-X8500BS CAUTION It is extremely dangerous to allow the microphone lead to become wound around the steering column or shift lever. Be sure to install the unit in such a way that it will not obstruct driving. Note Install the microphone in a position and orientation that will enable it to pick up the voice of the person operating the system. When installing the microphone on the sun visor 1 Fit the microphone lead into the groove. 1 2 1 2 1 Microphone clip 2 Clamp Use separately sold clamps to secure the lead where necessary inside the vehicle. When installing the microphone on the steering column 1 Detach the microphone base from the microphone clip. To detach the microphone base from the microphone clip, slide the microphone base. 1 1 Microphone lead 2 Groove 2 Install the microphone clip on the sun visor. 2 3 With the sun visor up, install the microphone clip. (Lowering the sun visor reduces the voice 1 Microphone recognition rate.) 2 Microphone clip 3 Microphone base 26 En