Pioneer DV-600AV-S Operating Instructions - Page 11

Connections 02 Chapter 2 Connections Easy connections Important • Before making or changing any connections, switch off the power and disconnect the power cable from the AC outlet. • The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In this setup, stereo audio is played through the speakers in your TV. • This player is equipped with copy protection technology. Do not connect this player to your TV via a VCR using audio/video or S-video cables, as the picture from this player will not appear properly on your TV. (This player may also not be compatible with some combination TV/VCRs for the same reason; refer to the manufacturer for more information.) To audio/video inputs TV White VIDEO OUT PB SL C L Red AC IN PR Y HDMI OUT COMPONENT VIDEO OUT S-VIDEO OUT DV-600AV SR SW R AUDIO OUT (5.1ch) Yellow OPTICAL COAXIAL DIGITAL AUDIO OUT To power outlet 1 Connect the VIDEO OUT and AUDIO OUT (5.1ch)/AUDIO OUT L/R jacks to a set of A/V inputs on your TV. Use the supplied audio/video cable, connecting the red and white plugs to the audio outputs and the yellow plug to the video output. Make sure you match up the left and right audio outputs with their corresponding inputs for correct stereo sound. See below if you want to use a component or S-video (DV-600AV only) cable for the video connection. 2 Connect the supplied AC power cable to the AC IN inlet, then plug into a power outlet. Note • Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front panel  STANDBY/ON button, or the remote control, and wait of the -OFF- message to disappear from the player's display. • For the above reasons, do not plug this player into a switched power supply found on some amplifiers and AV receivers. 11 En