Pioneer SC-LX904 11.2 Channel AV Receiver Owners Manual-English - Page 203
Speaker Setup, Full Auto MCACC, Symmetry default value: M1.Memory 1, All Channel Adjust
View all Pioneer SC-LX904 11.2 Channel AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ 1. Speaker Setup 1. Select the connected speaker configuration, and press ENTER. Note that the image on the screen changes each time you select the number of channels in "Speaker Channels". Speaker Setup Height 1 Speaker Height 2 Speaker Zone Speaker Speaker B Zone 2 Preout 7.1.4 ch 2 ch Top Front Top Rear Zone 2 Set the items on the second page with the cursor buttons / . Here you can save the measurement results for each speaker measured in "2.Full Auto MCACC" in the following 3 calibration types. Use / to select the memory location you want to save the results of the measurement to by item. If multiple calibration types are selected, you can select the calibration type to use in "AV Adjust" - "MCACC" - "MCACC Memory". Note that you cannot select the same save destination for different calibration types. Symmetry (default value: M1.Memory 1): Calibration that emphasizes phase characteristics All Channel Adjust (default value: ---): Calibration that emphasizes frequency characteristics Front Align (default value: ---): Calibration that emphasizes front speaker characteristics Press ENTER when you have finished the settings. Speaker Setup Symmetry All Channel Adjust Front Align M1.Memory 1 ----- 2. The speaker combination selected in step 1 is displayed. "Yes" is displayed for the selected speakers. If the setting is correct, press ENTER. 3. Select "Next" and press ENTER. Then a test tone is output from each speaker to confirm the connection. Selecting each speaker with the cursors / will output the test tone. Press ENTER after confirmation. 4. If there is no problem with the speaker connection, select "Next" and press ENTER. To return to "Speaker Setup", select "Back to Speaker Setup" and press ENTER. 2. Full Auto MCACC Place the supplied speaker setup microphone in the listening position, measure the test tones emitted by the speakers, then the unit automatically sets the optimum volume level for each speaker, the crossover frequencies, and the distance from the listening position. The influence of standing waves can be reduced to suit the listening environment, the reverberation characteristics can be measured to increase the precision of calibration, the speaker equalizers can be adjusted, and the difference in phase and timing between speakers and speaker units can be corrected. These settings and calibrations can be readjusted with Manual MCACC, and you can enable or disable them in AV Adjust. • It takes between 3 and 12 minutes for calibration to be completed. Each speaker outputs the test tone at high volume during measurement, so be careful of your surroundings. Also, keep the room as quiet as possible during measurement. • If you connect a subwoofer, check the power and volume of the subwoofer. Set the subwoofer volume to more than half. • If the power of this unit suddenly turns off, the wires in the speaker cables have touched the rear panel or other wires, and the protection circuit is working. Twist the wires again securely, and make sure they do not stick out of the speaker terminals when connecting. 1. Place the supplied speaker setup microphone at the listening position, and connect it to the SETUP MIC jack on the main unit. Select where the data is to be stored. Calibrates with emphasis on phase characterisƟcs. 203 Front Panel≫ Rear Panel≫ Remote≫