Pioneer VSX-21 Operating Instructions - Page 11

SET UP Connections Digital Connections Digital components can be connected as shown below. You can select up to four of the following be assigned to the digital inputs on this unit: DVD/LD, TV/SAT, MD/TAPE, CD, VCR1 (VCR). To assign the digital inputs, refer to "Setting Up for Surround Sound" on page 16. The digital signal input is output directly to digital recording components from the optical digital output jack. ANTENNA DIGITAL IN OPT 1 PCM/ /DTS FM UNBAL 75Ω OPT 2 DVD 5.1 CH INPUT OPT 3 SURROUND L SUBWOOFER AM LOOP ANTENNA S2 TO OUT MONITOR TV OPT DIGITAL OUT COAX R IN L PCM/ /DTS DIGITAL IN R CENTER OUT PLAY REC MD/TAPE 1 CONTROL OUT IN VIDEO OUT IN IN OUT PLAY REC CD TAPE 2 MONITOR IN IN IN OUT S2 S2 S2 S2 IN IN IN OUT IN IN IN OUT TV/ SAT DVD/ LD DVD 5.1 CH FRONT VCR 1 IN OUT S2 S2 VIDEO IN OUT IN OUT L R VCR 2 » DIGITAL OUT » COAX OUT » FRONT PREOUT L R FRONT SPEAKERS R L CENTER PREOUT L SORROUND PREOUT R SUBWOOFER PREOUT CENTER SPEAKER R L SURROUND SPEAKERS A B CAUTION: SEE INSTRUCTION MANUAL ATTENTION: SEE INSTRUCTION MANUAL 6~LESS THAN 8Ω /SPEAKER 6~MOINS DE 8Ω /HAUTPARLEUR 8~16Ω / SPEAKER 8~16Ω / SPEAKER IMPEDANCE SELECTOR » » AC OUTLET AC 120V 60Hz DIGITAL IN DIGITAL OUT DIGITAL OUT CD player DVD player memo When playing LD recorded in Dolby Digital When connecting a DVD/LD player or LD player using the AC-3 RF output, a commercially available RF demodulator (RFD-1) is required. The RF demodulator changes the RF signal to a digital signal which is then processed by the receiver through the digital input jacks. For more details, refer to the instruction manual supplied with the RFD-1. The factory setting for each of the digital inputs is described below. COAX : DVD OPT 1 : CD OPT 2 : MD OPT 3 : TV MD recorder TV tuner (or satellite tuner) 7 Digital audio cords/Optical cables Commercially available digital audio coaxial cords (standard video cords can also be used) or optical cables (not supplied) are used to connect digital components to this receiver. When you use optical digital input or output terminals, pull off the caps and insert the plugs. Be sure to insert completely. Digital audio cord Optical cable (or standard video cord) OPERATION 11