Pioneer VSX-21 Operating Instructions - Page 42

Other Operations Recording from Audio Components The following operations show you how to record audio to the cassette, DAT, or MD deck connected to the MD/TAPE 1 or TAPE 2 MONITOR jacks. memo The receiver's volume, balance, tone (BASS, TREBLE, and LOUDNESS), and surround effects have no effect on the recorded signal. RECEIVER TV MUTING FQ TV FUNC + ENTER - FQ VOL VOL CHANNEL 1 Select the component you want to record. Press SIG. SELECT on the remote or SIGNAL SELECT on the front panel to select "ANALOG" when making analog recordings, or "DIGITAL" when making digital recordings. (Refer to "Switching ANALOG/DIGITAL signal input" on page 29.) 2 Prepare the program source. (Tune in the radio station or load the CD, etc.) MULTI CONTROL DVD/LD TV/SAT CD VCR 1 TVCONTROL TUNER VCR 2 RECEIVER MD/TAPE DSP MODE MIDNIGHT 12 34 3 Insert a blank tape into the cassette deck (MD/TAPE 1 or TAPE 2 MONITOR) and adjust the recording level (if necessary). CH.SELECT TEST TONE ATT SIG.SELECT 56 7 8 CN.LEVEL EFFECT 4 SIG. SELECT Start recording on the cassette deck, then start playback 9 0 +10 MEMU from the source component. CLASS TV/VCR 1 FUNCTION DIRECT FL DIMMER MODE CHECK COMMANDER SET UP Î AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT Record monitor (TAPE 2 MONITOR) If you connect a cassette deck (etc.) with a record monitor function to the TAPE 2 MONITOR jacks, you can listen to the sound of the recording as it is being recorded. SIGNAL SELECT Press TAPE 2 MONITOR to switch between the sound of the recording (TAPE 2 indicator on) and the sound of the source component (TAPE 2 indicator off). memo • This receiver outputs the input signal directly to the recording device. As there is no conversion of the audio signal, recordings cannot be made from analog to digital, and similarly from digital to analog. 1 TAPE 2 MONITOR • Recordings cannot be made from TAPE 2 MONITOR to MD/TAPE 1. 42