Poulan 1400T User Manual
Poulan 1400T Manual
 |
View all Poulan 1400T manuals
Add to My Manuals
Save this manual to your list of manuals |
Poulan 1400T manual content summary:
- Poulan 1400T | User Manual - Page 1
Do Not Throw Away TRADEMARK® OPERATOR'S MANUAL: AWARNING: Read the Operator's Manual and Follow All Warnings and Safety Instructions. Failure To Do So Can Result in Serious Injuiy. Always Wear Eye Protection During Operation Model•• 1400 T • Tnynmer MANUFACTURED UNDER ONE OR MORE OF THE - Poulan 1400T | User Manual - Page 2
10 E. Air Filter 10 F. Trouble Shooting Chart 1 I WEED EX11.110 ACCESSORIES 11 PARIS AND SERVICE 12 12 13 14 SPECIFICATIONS 15 -+ STARTER ROPE HANDLE AIR FILTER STARTING INSTRUCTIONS OFF BUTTON SERIAL NUMBER y , ASSIST optional part. If this item is required in your area, order - Poulan 1400T | User Manual - Page 3
AWARNING THISPOWER TOOLCANBEDANGEROUS! Thistoolcan causeserious injuryorblindnesstothe operator and others. The warningsand safety instructions in this manual must be followed to provide reasonable safety and efficiency in using this tool. The operator is responsible for following the warningsand - Poulan 1400T | User Manual - Page 4
4 - Poulan 1400T | User Manual - Page 5
is running. 10. Use only for jobs explained in this manual. A MAINTENANCESAFETY 1. Maintain the tool according to recommended procedures. Keep shoulder strap for support. 4. Keepothers away when makingcarburetoradjustments. 5. Use only genuine WEED EATER° replacement parts as recommended by - Poulan 1400T | User Manual - Page 6
INSTRUCTIONS 1. Remove contents from the carton if you have not done so. 2. Check parts against the list below. 3. Examine parts fordamage. Donot usedamaged parts Trimmer Head Assist Handle Operator's Manual (not shown) Loose Parts Bag (not shown) ' * * LOOSE PARTS BAG CONTENTS: 6 Screw, Shield - Poulan 1400T | User Manual - Page 7
and is adjusted for the operator.) A. PREPARATION This Operator's Manual has been developed to help you assemble the tool and to straight end of the Drive Shaft Housing. Figure 1. c. Place the Clamp from the loose parts bag on the Engine Shroud as shown in Figure 1. d. Pull about 6 inches of the - Poulan 1400T | User Manual - Page 8
if it is necessary to tilt the angle of the Trimmer Head when cutting a large, sloped area such as a ditch bank. sttWitiltS1 WIDEST PART OF SHIELD RAISED AREA BOTTOM OF SHIELD "V"SLOIT SHOULDER DUST CUP KEYWAY KEY // SCREW S. t BRACKET HARDWARE SHOWN ACTUAL SIZE Figure 4 HARDWARE SHOWN ACTUAL - Poulan 1400T | User Manual - Page 9
2-cycle, air cooled engines. The internal design of the 2-cycle engine requires lubticationof moving parts. Lubrication isprovided when the recommended mixture of gasoline and oil is used. • Genuine POULAN/WEED EATER 40:1 Engine Oil is strongly recommended for the protection of your unit. Extensive - Poulan 1400T | User Manual - Page 10
Instructions in this manual. Before operating your tool, always: 1. Inspect the entire tool before each use. Replace damaged parts Extend line4-6 inches from Trimmer Head to pro- vide adequate load on engine. Figure Rest engine and Shield on ground, supporting Trimmer Head off ground away from trees, - Poulan 1400T | User Manual - Page 11
D. OPERATING INSTRUCTIONS 1. Bringtheenginetocuttingspeed beforeenteringthe material to be cut. a. Do not run 'Pap-N-Go HTM Trimmer Head M52-'701604 Use Only Genuine Weed Eater® Parts AWARNING DAMAGED TRIMMER HEAD Trimmer head parts that are chipped, cracked, or damaged in any way can fly apart - Poulan 1400T | User Manual - Page 12
Inspect the entire tool before each use. Replace damaged parts. Check for fuel leaks and make sure all fasteners do not use the optional shoulder strap for support. f. Keep others away when making carburetor i. Use only for jobs explained in this manual. B. TRIMMER LINE ADVANCE • The line will - Poulan 1400T | User Manual - Page 13
the ground around trees, posts, monuments, etc. This technique increases line wear 3. MOWING - Figure 14 Your trimmer is ideal formowing in placesconventional lawn mowers cannot reach. In the mowing position, keep the line parallel to the ground. Avoid pressing the head into the ground as this can - Poulan 1400T | User Manual - Page 14
Cover counterclockwise b. Remove the Lock Ring and Spool. Figure 17. c. Clean dirt and debris from all parts. Inspect all Trim- mer Head parts for damage. Replace damaged parts. A WARNING Trimmer head parts that are chipped, cracked, or damaged in any way can fly apart and cause serious injury. Do - Poulan 1400T | User Manual - Page 15
except for carburetor adjustments. 3. Makecarburetoradjustments with thedriveshaft housing supported to prevent the trimmer line from contacting any object genuine WEED EATER® replacement parts as recommended by the manufacturer. 8. Inspect entire tool. Replace damaged parts. Check for fuel leaks. - Poulan 1400T | User Manual - Page 16
repair. A WARNING Always wear eye protection and gloves when servicing thestarter rope. The recoilspring, located beneath the pulley, end of rope through rope exit hole to the inside of the fan housing. 15. Guide rope inside pulley, then up through the pulley ratchet side of pulley hole to the - Poulan 1400T | User Manual - Page 17
stored for 90 days or longer. • Use WEED EATER® Flex Shaft Lube Part No. 530-030102. • Use the following procedure for best results: A WARNING Replace Flexible Drive Shaft in the Drive Shaft Housing. 8. Follow the instructions in 'Assembly" to replace Drive Shaft Housing into the Engine Shroud. - Poulan 1400T | User Manual - Page 18
while making mixture screw adjustments as damage to the engine can occur. a. Support the drive shaft housing so that the trimmer head is off the ground to a qualified service dealer. 5.REINSTALLAIR FILTER Be sure filter is clean. See "Air Filter" for instructions. [CAUTION: - Poulan 1400T | User Manual - Page 19
TROUBLE fuel mixture. 2. See "Starting Instructions." 3. Install new plug/check ignition Contact a qualified service dealer. 5. Contact a qualified service dealer. 1. Clean CAP AIR FILTER SPARK PLUG MUFFLER GUARD KIT ILLUSTRATED PARTS LIST OPERATOR'S MANUAL STOCK NO. 952-003039 952-030117 952-030119 - Poulan 1400T | User Manual - Page 20
,Brushcutters,and Blowers) or Skil Service Center (under "tools-electric"). 2. For replacement parts have available the following information: a. Description of the unit. b. Model number. c. Part Number or description of part. NOTE: Poulan/Wepil Eater Division provides parts and service through its
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
IMPORTANT
MANUAL
Do
Not
Throw
Away
TRADEMARK®
OPERATOR'S
MANUAL:
AWARNING:
Read
the
Operator's
Manual
and
Follow
All
Warnings
and
Safety
Instructions.
Failure
To
Do
So
Can
Result
in
Serious
Injuiy.
Always
Wear
Eye
Protection
During
Operation
Model
•
•
1400
T
•
Tnynmer
MANUFACTURED
UNDER
ONE
OR
MORE
OF
THE
FOLLOWING
U.S.
PATENTS:
3,708.967;
3,826,068; 3.859,776;
O35.912:
4,052.789;
4054,922;
4,067.108;4.104,797;
4244,269;
4,124,938;
4,156,32;
4156.967:4,161,820;
4,167)312:
4.269.372;4,269,675,4.508068;
DES.249.630;
DES.255,764;
DES.260.394.
U.S.
AND
FOREIGN
PATENTS
PENDING.