SERVICE AND ADJUSTMENTS (TRIMMER ATTACHMENT) REPLACING THE LINE 1. Press the tabs on the side of the trimmer head and remove cover and spool. 6. Bend the line at the midpoint and insert the bend into the slot in the center rim of the spool. Ensure line snaps into position in the slot. Slot Tab Tab 7. With your finger between the lines, wrap the lines evenly and firmly around the spool in a clockwise direction. Cover Spool 8. Position the lines in the guide slots. Guide slot 2. Remove any remaining line. 3. Clean dirt and debris from all parts. Replace spool if it is worn or damaged. 4. Replace with a pre-wound spool, or replace line using a 25 feet (8 meters) length of 0.080 inch (2 mm) diameter line. Guide slot WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous projectile. 5. When installing new line on an existing spool, hold the spool as shown. 22 9. Place the spool in the cover as shown below.