ProForm 250i Elliptical English Manual - Page 23

HOW TO CONNECT YOUR HEART RATE MONITOR TO THE CONSOLE The console is compatible with all BLUETOOTH Smart heart rate monitors. THE SETTINGS MODE The console features a settings mode that allows you to select a unit of measurement for the console and to view console usage information. To connect your BLUETOOTH Smart heart rate monitor to the console, press the IFit Sync button on the console. When a connection is established, the LED on the console will flash red twice. Note: If there is more than one compatible heart rate monitor near the console, the console will connect to the heart rate monitor with the strongest signal. To disconnect your heart rate monitor from the console, press and hold the IFit Sync button on the console for 5 seconds. Note: All BLUETOOTH connections between the console and other devices (including any smart devices, heart rate monitors, and so forth) will be disconnected. To select the settings mode, press and hold down the On/Reset button until the settings mode information appears in the display. The console can show pedaling speed and distance in either miles or kilometers. The upper display will show the selected unit of measurement. An E for English miles or an M for metric kilometers will appear in the display. To change the unit of measurement, press the Intensity button repeatedly. Note: When you replace the batteries, it may be necessary to reselect the unit of measurement. Press the Wt. Loss button to view the total distance and the total time. The center display will show the total time (in hours) that the console has been used since the elliptical was purchased. The lower display will show the total distance (in miles or kilometers) that the elliptical has been pedaled. To exit the settings mode, press the Wt. Loss button repeatedly. 23