ProForm 280 Razor Instruction Manual - Page 7
Tip: To prevent the Wire Harness 86
View all ProForm 280 Razor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Tip: Avoid pinching the Wire Harness (86). Start all screws before tightening any of them. Have another person hold the Upright (2) near the Frame (1). Locate the wire tie in the Upright (2). Tie the lower end of the wire tie to the Wire Harness (86). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness (86) from falling inside the Upright (2), secure the Wire Harness with a rubber band. Attach the Upright (2) to the Frame (1) with four M10 x 20mm Button Screws (79) and four M10 Split Washers (78). Do not tighten the Button Screws yet. 3 Avoid pinching the Wire Harness (86) 2 79 78 86 1 78 79 78 79 Wire Tie 4. Slide the Console Cover (96) onto the Upright (2) and move it downward. 4 Then, insert the Console Bracket (3) into the top of the Upright (2). Tip: Avoid pinching the Wire Harness (86). Attach the Console Bracket (3) with four M6 x 18mm Patch Screws (102) and four M6 Split Washers (101). 86 102 101 2 3 101 102 96 Avoid pinching the Wire Harness (86) 7