ProForm 380 F Elliptical English Manual - Page 10

10. Apply a generous amount of the included grease to the Pivot Axle (16). Then, apply a 10 small amount of grease to two Wave Washers (88). Insert the Pivot Axle (16) into the Upright (2). 80 20 Place a Wave Washer (88) on each end of the Pivot Axle. 2 Slide the right Upper Body Leg (6) onto the Pivot Axle (16). Attach the right Upper Body Leg with an M6 x 16mm Patch Screw (80) and a Large Axle Cover (20). Attach the left Upper Body Leg (6) in the same way. 6 88 16 88 Grease 20 80 6 11. Apply a small amount of grease to a Pedal Arm Axle (21). While another person holds the right Pedal Arm (14) inside the bracket on the right Upper Body Leg (6), insert the Pedal Arm Axle through the Upper Body Leg and the Pedal Arm. Then, tighten an M6 x 16mm Patch Screw (80) and an Axle Cover (22) into each end of the Pedal Arm Axle (21). Repeat this step for the other side of the elliptical exerciser. 11 14 6 80 22 14 6 Grease 21 22 80 12. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 10