ProForm 380 F Elliptical English Manual - Page 7

3. Tip: Be careful not to pinch the Wire Harness (100). Start all screws before tight- 3 ening any of them. Have another person hold the Upright (2) near the Frame (1). Locate the wire tie in the Upright. Tie the lower end of the wire tie to the Wire Harness (100). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness from falling inside the Upright (2), secure the Wire Harness with a rubber band. Attach the Upright (2) to the Frame (1) with four M10 x 20mm Patch Screws (79), and four M10 Split Washers (78). Tip: Tighten the two Button Screws on the front of the elliptical exerciser before tightening the other two Button Screws. Wire Tie 2 Avoid pinching the Wire Harness (100) 79 78 100 1 78 79 78 79 4. Tip: Be careful not to pinch the Wire Harness (100). 4 Orient the Water Bottle Holder (5) as shown and slide it onto the Upright (2). Attach the Water Bottle Holder with two M4 x 32mm Screws (95). Slide the Console Cover (96) onto the Upright (2) and move it downward to the Water Bottle Holder (5). Then, insert the Console Bracket (3) into the top of the Upright. Attach the Console Bracket with four M4 x 16mm Screws (84). 3 96 100 84 84 2 5 95 7