ProForm 480 Cse Elliptical English Manual - Page 11

11. Apply a generous amount of grease to the axle of the Right Crank Arm (24). Then, apply a small amount of grease to two 23mm x 19.5mm Wave Washers (49). Slide a Crank Arm Spacer (25) and the Right Pedal Leg (12) onto the axle of the Right Crank Arm (24). Make sure that the flat side of the Crank Arm Spacer is facing away from the Right Crank Arm. Attach the Right Pedal Leg (12) with an M8 x 25mm Patch Screw (83), an M8 Small Washer (88), a Pedal Leg Cover (50), and one of the 23mm x 19.5mm Wave Washers (49). Do not tighten the Patch Screw yet. Attach the Left Pedal Leg (not shown) in the same way. 11 Grease 24 25 49 50 88 83 12 12. Orient a Link Arm (13) as shown. Apply a small amount of grease to the axles on the Link Arm and to two 22mm x 16.5mm Wave Washers (70). Then, slide a Wave Washer onto each axle. Identify a Link Arm Spacer (48) and a Rear Link Arm Spacer (38); the Link Arm Spacer is longer than the Rear Link Arm Spacer. Orient the Link Arm Spacer and the Rear Link Arm Spacer as shown. Slide the Link Arm Spacer (48) onto the front axle of the Link Arm (13); slide the Rear Link Arm Spacer (38) onto the rear axle. At the same time, slide the Link Arm (13) into the left Upper Body Leg (9) and into the Left Pedal Leg (11). Attach the Link Arm with two M6 x 16mm Patch Screws (96) and two M6 Large Washers (87). Repeat this step on the right side of the elliptical exerciser. See step 3. Tighten the M8 x 70mm Button Bolts (66). See steps 7, 8, and 11. Tighten the M8 x 25mm Patch Screws (83). See the inset drawing. Press an Upper Body Leg Cover (42) onto each Upper Body Leg (9). 12 13 70 38 9 70 48 Grease 11 87 96 87 96 42 9 42 9 13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 11