ProForm 625 Treadmill User Manual - Page 7

4. With the help of a second person, carefully tip the Uprights (82, 122 [not shown]) to the vertical position. 4 Feed the Wire Harness (34) through the indicated hole near the top of the Right Upright (82). Hold the Pulse Bar (109) near the Right Upright (82). Feed the wire in the Pulse Bar into the hole in the side of the Upright and out of the hole near the top of the Upright. Insert the tabs on the end of the Pulse Bar into the Right Upright. If necessary, pull back the foam on the Pulse Bar. Orient the Pulse Bar with the pulse sensors on top as shown. Attach the Pulse Bar between the Uprights with two 3 1/2" Bolts (107). Do not to pinch the wires. 5. Attach the Latch Assembly (9) and the Latch Spacer (56) to the Left Upright (122) with two 3/4" Tek Screws (101) 5 as shown. 34 Wire Hole 109 107 82 56 9 122 101 6. Insert a Handrail Extension (85) into the post on the Left Upright (122). Align the holes in the Handrail Extension with the holes in the post. If necessary, tap the Handrail Extension with a rubber mallet to fully insert it. Next, attach the Handrail Extension by tightening three 1/2" Tek Screws (76) into the indicated holes. Note: If there is only one hole in the top of the post, tighten the third Screw into the hole in the left side of the post. Identify the Left Foam Grip (110), which has a large cutout in the right side. Slide the Left Foam Grip as far as possible onto the post on the Left Upright (122). It may be helpful to apply soapy water to the Handrail Extension (85). 6 110 7. Tighten a 1/2" Tek Screw (76) into the side of the Left Foam Grip (110) as shown. Note: You may need to pull 7 on the side of the Left Foam Grip to align the screw hole with the hole in the Left Upright (122). Attach the Right Foam Grip (not shown) and the other Handrail Extension (not shown) as described in step 6 and this step. Post 76 85 76 Cutout 122 76 110 122 7