ProForm 735 English Manual - Page 10

12. Press two 3/4Ó Round Inner Caps (54) into each of the three Pad Tubes (38). Slide a Foam Pad (10) onto one end of each Pad Tube (38). Insert the free end of each Pad Tube (38) into the indicated holes in the Leg Lever (18) and the bracket on the Front Leg (19). Secure each Pad Tube by sliding another Foam Pad (10) onto the free end. 12 54 10 38 19 54 18 54 38 54 54 10 10 38 10 13. Locate the Cable (45) and note that it has a loop on 13 one end and a ball on the other end. Insert the end with the loop through the slot in the Lat Tower (9) from the direction shown. 45 17 Next, lay the Cable (45) in the groove of the Pulley (35). Attach the Pulley inside the slot in the Lat Tower 34 6 (9) with the M10 x 68mm Bolt (34), two M10 Washers (6), two Pulley Spacers (41), and an M10 Nylon Locknut (11). Press a 2Ó Square Inner Cap (17) into the top of the 41 Lat Tower (9). 11 6 35 41 9 14. Press Carriage Bushings (2) onto the top and bottom of the Weight Carriage (47). Press a 1Ó Round Inner Cap (12) into the weight tube on the Weight Carriage. Insert the M10 x 19mm Bolt (46) into the bracket on the Weight Carriage (47) from the indicated direction. Press the last Carriage Bushing (2) into the Carriage Stop (24) as shown. 14 Bracket 12 Weight Tube 10 2 46 2 47 24 2