ProForm 735 English Manual - Page 6

Assembly Before beginning assembly, carefully read the following information and instructions: Make Things Easier for Yourself! Everything in this manual is designed to ensure that our products can be assembled successfully by anyone. However, it is important to recognize that this is a sophisticated product with many small parts, and, consequently, the assembly process will take time. Most people find that by setting aside plenty of time and by deciding to make the task enjoyable, assembly will go smoothly. ¥ Assembly requires two people. ¥ Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. ¥ Tighten all parts as you assemble them, unless instructed to do otherwise. ¥ For help identifying the small parts, use the PART IDENTIFICATION CHART on page 5. ¥ As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. The following tools (not included) are required for assembly: ¥ Two (2) adjustable wrenches ¥ One (1) rubber mallet ¥ One (1) standard screwdriver ¥ One (1) phillips screwdriver ¥ Lubricant, such as grease or petroleum jelly plus soapy water. Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches or a set of ratchet wrenches. 1. Before assembling this product, make sure you 1 understand the information in the box above. Press a 51mm x 76mm Square Inner Cap (53) into the top of the Right Upright (1). Note: Make sure the adjustment brackets are oriented as shown. Press a 2Ó Square Inner Cap (17) into each end of the Right Stabilizer (26). Insert four M10 x 62mm Carriage Bolts (33) up through the Right Stabilizer (26). (Note: On one side of the Stabilizer there is an indentation around each hole. Insert the Bolts from this side.) Place the right Stabilizer flat on the floor. Slide the Right Upright (1) onto the four M10 x 62mm Carriage Bolts (33) in the Right Stabilizer (26). Attach the Upright with four M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet. Set the Right Upright (1) aside, making sure that it cannot fall. 6 53 1 Adjustment Brackets 11 11 17 26 17 33 33